BeeWire Lite is the perfect solution for adding LED's to your racing or freestyle drone which helps prevent mid-airs during racing, while at the same time providing a simple and easy solution for swapping motors in the field with as little down time as possible.
BeeWire is made from a durable and thick 1.7mm PCB board, making your quad safe against prop strikes that would otherwise cut motor wires while merely scraping the surface of the BeeWire board.
BeeWire changes it's brightness based on how fast your motors are spinning. The faster you fly, the brighter your L.E.D.'s become!
You can customize the color of your RGB L.E.D.'s thanks to the 3 pads on the board and choose between Green/Blue/Red/Purple/Cyan/Yellow/White! Simply bridge the pads to the corresponding colors to achieve the color of your choice.
Super-Stick pads! We also include 5 Super-Stick pads that give a layer of isolation from your carbon arm, and provide a super sticky pad that will hold onto the arm. You can also wash these pads once they get dirty! Simply rinse in clean water with soap, rinse again and let air dry and they are back to the original stickiness!
I have bee wire on my current race rigs and they work and look great! They come in a five pack with really strong double side tape. The LEDs are really bright when your on the throttle and so far have taken a real beating flying over concrete.
I am kinda new to fpv drone flying but not new to RC and this radio is by far the best I’ve used. Definitely complicated and has a lot to lean but its loaded with features and is fully customizable and way more advanced then anything Ive used before. Coming from the Spektrum platform YouTube is your friend as there is a lot to learn.
had a few issues i used they ROBO 1002 and it fit fine without they carbon. but needs they carbon to hold battery had to use a mix of screws, had issues with props rubbing they frame with carbon using AZI props solved by not pressing props all the way down. I ordered they black and yellow, Black has a better mount for they antenna to keep in place !! yellow needs something to tie down
this gift would be nicer with a genuine properly welded whoop
Hello Franz,Thank you for the information provided. Do you have a hot air soldering station? You can use it to heat the capacitor, which should allow you to reseat it into position. After that, test to see if it's functioning properly within Betaflight. If everything is working correctly, you can further secure the capacitor with non-conductive adhesive.We sincerely apologize for the inconvenience caused. We have also credited your account with $10, which you can use to purchase any products from our store. If you have any questions or need further assistance, please feel free to reach out to us. We are always here to help. Thank you, NewBeeDrone Support
forgive waranty, buy an hot air soldering unit before !!!
Hello Franz,
Thank you for the information provided. Do you have a hot air soldering station? You can use it to heat the capacitor, which should allow you to reseat it into position. After that, test to see if it's functioning properly within Betaflight. If everything is working correctly, you can further secure the capacitor with non-conductive adhesive.We sincerely apologize for the inconvenience caused. We have also credited your account with $10, which you can use to purchase any products from our store. If you have any questions or need further assistance, please feel free to reach out to us. We are always here to help.