This is our second generation motor design, we use unibell on this motor at the same time we switch to double step shaft. Without the C-Clips on top of the bell will make the motor balance to the next level. This motor is design to operate under 2S voltage ( 7.4V)
These motors come with JST-1.0 plugs installed but also come with a set of Micro JST-1.25's. The BeeBrain Brushless uses Flight controller uses JST-1.0 plugs.
Love these little motors in and they're great for 2s whoops
L
Lamont
Wobble = heat
Got these for a 75mm build on a mobula v3 frame replacing my happymodel motors for a new elrs build . All 4 of these are very loose on the shaft and have a lot of play at the bell causing excessive heat. These are unfortunately unusable . Only got about 8 flights out of these before they became completely unreliable.
C
Christopher H.
Running these 2s with bee brain v3
Great motors. Installed on a 75mm frame.
M
Michael
Espresso for 2s
This is my first experience with Newbeedrone on 2s. I used these because I snapped a shaft on my older set. These are holding up to the abuse.
I did use the suggested esc settings from the Hive group page and no problems from these. So far, awesome change.
I am using 40mm 3 blade pros at the moment and not planning on changing that for now.
These batteries performed noticeably better than the other 300mAh and 350 mAh batteries from competitors. If you're leisurely flying, the cheaper batteries will work, but if you want to have more power throughout the charge of the battery, these are better. On the downside, they cost more than the competition. Also, note that I soldered xt30 connectors because that was the connector on the drone we were using. So, I can't comment on the performance on the GNB27 connection
Works great. I've got 3 quads with this receiver now. It seems to be good quality, connected and flashed by wifi after soldering up. Binding went easily with the Radiomaster Pocket and I was off flying.