Talon F4 is back and better than ever! We managed to add black box and vtx pit switching to the small 20X20 footprint! Pair it up with our Talon Gigawatt 4 in 1 ESC for a lightweight powerful 20X20 stack ideal for racing, or to save some weight on your freestyle builds!
Direct 2-6S input
Built in Betaflight OSD.
4 in 1 ESC socket and direct solder on 4 in 1 ESC pads.
Built in camera control resistor and capacitor
Anchor USB port, for more security and durability
Filtered 5V for camera, vbat battery for VTX.
Current sensor input from 4 IN 1 esc socket and solder pad
Inverter for Sbus (on UART1), (Protocol selectable)
Inverter for smart port telemetry(UART3)
TX4(uart4) near VTX pads for easy smart audio or tramp wiring
TX6(uart6 ) and RX4 ( uart4 )
VTX pit mode switch for 5v and vbat selection
16M blackbox chip
To use VTX Pit switch please use the custom firmware in the link below. This will be incorporated into the next master release of Betaflight.
Betaflight 3.5.7 Hex
Betaflight 4.0.3 Hex
If you don't want to use VTX Pit switch please enter this code into the cli to keep it always on. aux 0 39 0 900 2100 0 0
If you want to use clracingf4 4.0.4 for your Talon F4 V2, please follow these instructions below. On Talon F4 v2. If you want to use the last CLRACING F4 target 4.0.4 Here is the command to make it work Resource flash_cs B12 If you don’t want to use the pit mode switch. Enter this in the cli
Resource flash_cs B12 set flash_spi_bus = 2 aux 0 39 0 900 2100 0 0
To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit
Setting up Pit Mode:
The number after the RX and TX indicates what uart those rx and tx line is on, for example.
RX6 AND TX6, means, rx line and tx line on uart6.
Sbus pad -> uart1 rx
Talon F4 V2 and Gigawatt Pinout