Axisflying Fpv Brushless Motor C224 2204.5 For 3.5inch Cinewhoop and Cinematic Drone
With FPV trending in cinematic and commercial filming, we – Axisflying – are very proud to present you our new C cinematic motor series.
The C series motor has been developed for Cinematic FPV pilots who fly to create and have high-quality requirements.
Cinematic pilots often only have one chance to capture their best shot so they work hard to fine-tune their flying abilities and master: control, anticipation and precision. We bring you today a new cinematic motor to help you enhance your cinematic flying skills.
The C series motor features the perfect balance required for your cinematic flights: smoothness, reactivity and high torque for a delicate control feel along high efficiency to maximize your flight time.
*Forword
- C224 motor is special designed for 3.5inch cinewhoop and cinematic drone that need more powerful and torque.
- It is easy to carry heavy GoPro10 or GoPro11.
- C224 motors run perfect with Gemfan D90-3 or HQ D90-3 props.
- There are 2 KV for options 2300KV @6S ,3500KV@4S
*Bearing Shield Technology
- An IP53 rating dustproof and waterproof bearing placement design.
- BST protects from environmental elements and prolongs the smoothness and lifespan of the bearng .
- Increased thrust effciency and say goodbye to crush motor bearings
*Specs
- 2300KV is for 6S / 3500 KV is for 4S
- Configuration: 12N14P / N52H arc magnet
- Motor stator size: 2204.5
- Motor mounting hole size: 4*M2 (Φ12mm)
- Motor cables: AWG 20#, 150MM
- Motor dimensions (Dia *Len): Φ26.9*28.8MM / M5 shaft
- Motor weight (including 150MM cables) : 21g
- The motor is very powerful that can get over 0.85KG and most current is about 25A
Good flier, handles the abuse a new flier like me has put it through
First prebuild from NBD. I swapped out the tracer RX for crossfire, initially had a no gyro flag on the AIO but was able to get it sorted with NBD support. Flying it is a good time and it’s held up well to some decent crashes. So far only thing(s) I’ve needed to replace has been a propeller and a M3x20 standoff. Took me too long to notice but the 2 aluminum pieces are for taking the O3 air unit from 25x25 mounting and making it 20x20.