iFlight BLITZ M10 GPS+ TPU Mount for Nazgul Evoque F5/F6
Product features:
Using the latest UBLOX M10 chip, lower power consumption, faster star search speed.
Built-in high precision compass QMC5883L. 3.
Built-in Faraday capacitor, with 1-10Hz positioning update rate, which makes GPS have faster startup speed and star receiving speed.
18*18mm ceramic antenna provides the best balance and performance for current GPS modules, low power consumption, strong signal and light weight.
On-board LNA low noise amplifier and RF filter provide excellent working environment for GPS module.
Up to 10HZ refresh rate.
Built-in Flash, users can set GPS parameters by themselves using U-center or other software, configuration modification will be stored to Flash, no loss of parameters after power failure.
Product parameters:
GPS module protocol: Ublox/NMEA
Speed accuracy: 0.05m/s
Cold start: 26 s
Hot start: 1 s
Tracking sensitivity: -167dBm
Input voltage: 3.3~5.5V(typical 5V)
Maximum altitude: 50000m
Maximum speed: 500m/s
Maximum acceleration: ≤ 4G
Baud rate: 4800-115200bps (115200bps recommended)
GPS module size:20*21*6.5mm
Antenna size: 18*18
Weight: 5.2 g (±0.5g)
pin definition:
1.VCC: system main power supply, supply voltage is 5V, current is about 40mA when working
2.GND: Ground
RXD: data input
4.TXD: Data output
5.SDA: Serial Data - I2C Master/Slave Data
6.DCL: Serial Clock - I2C Master/Slave Clock
Definition of indicators:
Blue light, TX light, the blue light blinks on power up, indicating that there is data output.
Red light, PPS light, not positioned red light is not lit, 3D positioning, the red light began to flash.
Right away, this is the best 65mm Whoop I know. Not even close.
I ordered two, one is more or less stock, just the PEEK motor screws and V3 cockroach. The second is upgraded to 0702 27000kV but will go back because I like the 25000kV more because of smoother throttle response and perfect betaflight tune.
Now the but:
1. On both quads I had to replace the BeeEye for a spare one because both are out of focus.
2. the yellow props were way too loose and very brittle. I lost two on my maiden. Black, blue and red are very tight (too tight for such a fragile prop) but if you get them on without bending them, they will last.
3. why does the quad not come with the lighter frame right away?
4. PH2.0…. You know the drill.
On that price point, even after the frame and PEEK upgrade I can forgive these quality issues. Especially considering the great tune and quality FC and motors. But be sure to order a replacement cam and props right away.
This was kind of a late night lark. I'd seen this upgrade for the Mk3 for a while and pondered whether it was a gimmick or not, and I'm pleased to say it's a genuinely good upgrade. It has reduced the noise of my Mk3 considerably. I haven't noted any significant increase in print quality, but the old drone of the bed is gone and that's completely worth it.
