The Squirt started out as a special project for Robert McIntosh, Godfather of slow super proximity cinematic flying. Thanks to improvements to the Hero and content from great pilots like Nurk, it became part of a new movement dubbed Cinewhooping by Nurk.
Features
160mm 3" ducted quad
Generates about 240g more thrust, so the Squirt V2 is a peppy flyer that can carry a Hero.
It doubles as prop guards, so it's safer to fly in close proximity to people.
Comes with 3D parts and Hero Mount.
Note: No electronics included (camera, antenna, motors, etc.)
Recommended
4-in-1 ESC
1407 3200kv motors
36x36/20x20 stack
Micro cam (for FPV camera mount)
HQ 4x4.3x3 props to 3" (for best performance)
May use a bullnose to hug the ducts
Keep the gap at a minimum for maximum efficiency
Includes
1 x Shen Drones Squirt V2 with Variable Angle Hero Mount
Still building it, but this sucker gets five stars for completeness. Seems to have a double supply of screws and standoffs, plus it comes with a full set of TPU bits—antenna mount, xt30 mount, a little sled for the receiver, and shoes—that you won’t get from cncdrones.
These batteries might actually be worth it in terms of dollars per flight time! They last over five minutes when my old lower end batteries last three minutes, and they’ve even lasted for seven on a freestyle quad in a tight environment. Plus it’s always fun to have a battery that can actually kind of handle full throttle for extended periods!
I tried to be cheap and find crappy clones of all these tools... it's not cheaper, it's very expensive to buy just a prop wrench, just a m3 nylock wrench and buying hex drivers and wire strippers. It totalled me 90$. This ethix toolkit was cheaper and got me exactly what I wanted and needed for my drone kit