0 Cart
Added to Cart
    You have items in your cart
    You have 1 item in your cart
    Check Out Continue Shopping

    The Blaster Motor is back - now available in both 2450KV and 1800KV! And the Blaster Replacement Program has been extended indefinitely!

    When initially released, the Blaster Motors were made with one specific purpose - to let you fly hard and push your limits, develop your skills and become a better pilot, without taking a toll on your wallet!

    By owning Blaster Motors, you are automatically covered by the Blaster Replacement Program. This means that if your motor breaks or wears out, you can replace it at a very low cost!

    The 1800KV Blaster Motor's construction is the same as the durable 2450KV Blaster Motors. The bell is made from aluminum, anodized to a distinctive dark red color, while the steel magnet ring is silver with black accents. The distinctive bell is supported by a hollow-core steel shaft, and held in place with a hex screw that facilitates motor service.

    Following the trend of lower KV and higher voltage batteries, the new Blaster Motors have been designed to run at 1800KV. This makes it an ideal choice for pilots who are considering moving to 6S to enjoy extended flight times and less power sag.

    The Blaster Motor does not make any compromises when it comes to durability or performance. The open design allows the motor to dissipate heat more easily and facilitates cleaning and maintenance compared to fully enclosed motors.

    The base follows the standard Hypetrain 16x16mm mounting screw layout, which optimizes mounting options, maintaining compatibility with older frames and saving a little bit of weight.


    • Unique Bell Design
    • Machined Aluminum Top and Bottom
    • Hollow Stainless Steel Shaft
    • Shaft Screw (No C-clip)
    • "Naked Bottom" Design
    • Copper Windings
    • Silicone Sheathed Wires
    • Square Mounting Pattern
    • Unique Serial Number on the Motor Base


    • Model: Hypetrain BLASTER 1800KV
    • KV: 1800KV
    • Stator Diameter: 22 mm
    • Stator Height: 7 mm
    • Propeller Shaft Size: M5
    • Wires: 118 mm 20AWG Silicone Sheath
    • Bell Material: 6061 Aluminum
    • Magnets: N50 Curved Magnets
    • Mounting Screw Pattern: 16 x 16 mm
    • Input Voltage: 4-6S
    • Bearings: NMB