Have you been waiting for a full HD 2" rig? If so wait no more, this setup is using the Caddx Vista and the new Caddx Nebula cam in a new 2inch whoop frame. They also did some tuning and tried to find the optimal ratio between weight and power. This is what they came up with to combine flight time efficiency with sufficient power.
Features:
84.5 grams (without battery)
Butter smooth XING-E 1303 more torque and efficiency with longer flight times compared to 1105 motors
Ducts to protect the sensitive environment or yourself
Pre-tuned with smooth cinematic settings
iFlight Sigma 5.8G light antenna upgrade
iFlight Sigma 900mhz light micro antenna upgrade
Alpha A85 HD BNF Specs:
SucceX-D 20A F4 Whoop AIO
Motor: XING-E 1303 5000KV
Wheelbase: 85mm
Body size: 125*125mm
Ducted propeller size: 2 inch
FC pattern: 25.5*25.5mm
FPV cam spacing: 14mm
Weight: 84.5g (without battery)
Flight time: 5-7 min cruising (4S 450mAh)
FACTORY SETUP and WIRING DIAGRAM:
This BNF comes pre-built and setup with all necessary parameters to bind-and-fly. We also added a basic filter and PID tuning as well as some more secret Betaflight sauce to enhance the flight experience.
Reflashed your drone but didn't backup the setup? Messed up the whole tune and want our factory tune back? No need to worry! All Factory Dumps and Wiring Diagrams can be found on our Google Drive: LINK
Alpha A85 HD Quad BNF Included Components and Parts
Prebuilt and tested Quadcopter
1x Alpha 85mm Frame
1x Caddx Nebula Digital HD System Kit
1x iFlight Sigma 5.8g light antenna
2 sets HQ 2 inch 4-blades (Set of 4 - Color May Vary)
1x iFlight Lipo Strap
FC // SucceX-D 20A F4 Whoop AIO
SucceX-D 20A F4 Whoop AIO
Size 30.5*30.5mm
Mounting pattern 25.5*25.5mm/3mm
Connector Micro-USB
MCU STM32F411
Gyro MPU6000
Blackbox 8MB
BEC output 5V 2A/10V 2A
INA pad UART2 (nR2) 
Barometer no
Constant current 20A 25A Burst
Input 2-5S
Current sensor yes
BLHeli / BLHeli-S
Telemetry no
Target IFLIGHT_F411_PRO
Config IFLIGHT_F411_PRO.config
ESC Firmware G-H-30 BLS
Additional Suggested Parts
DJI HD FPV Goggles
Radio Controller
Battery 4S 450mAh
Important
The DJI Remote Controller is recommended for beginners since you won't need to set up another receiver, but it is also optional in this BNF drone because it is NOT required in order to use the FPV system. If you don't choose to use the DJI Remote Controller, you can choose a receiver option for your transmitter and then bind to your own radio as usual.
Great first Quad if you have DJI goggles and Transmitter
Make sure you have the FPV specific DJI assistant 2 software and activate and update the firmware for the CADDX VISTA. Charge a 4S 450mA and bind to goggles first then to the radio. Angle mode is great for the first few flights.
J
J.T.
Amazing!
Loving it so far. First time FPV pilot and after a couple of days I’m already doing flips and roll in acro mode.
