Meteor65, a leading 1S whoop WINTER TIME drone. It's equipped with the BT2.0 connector, lightest F4 1S FC and 0802SE 19500KV motors. With the stronger and powerful dynamical system, you’ll immediately notice how fantastic the 22.84g Meteor racer is at takeoff. It feels amazing as you hover around indoors, then let it rip and haul around the house!
What's more, Meteor65 comes back on 30th March as a kit, it is with abundant accessories of 2 lipo batteries, a BT2.0 charger & tester, extra 1 set of props, 1 screwdriver and a portable bag. It is easy to use and at a reasonable price! Also, the camera angle has been adjusted to 30°, which brings you a greater flying experience!
The TBS Crossfire Nano receiver with minimal T Crossfire antenna is available on the Meteor series for all CRSF users. This specific variation is only designed to be small, light, and easy to use.
This antenna is designed by Michael Anderson, produced by FPVCycle and manufactured by TBS
The performance of a 65mm 1S brushless drone has gone up a new level this winter. What is your exception for this drone? Aggressive power and faster speed, or longer flying time? Here is the comparison of different motors.
0802-22000KV
0802-19500KV 0603-19000KV
0603-16000KV
Flying Time
1:30-2:00min
3:30-4:00min
4:10min
Speed & Power
Ultra Insane
Insane
Insane
Thanks for the feedback and advice fromNate Payneand Michael Huddleson. Right now you could choose these spare motors like 0802SE 19500KV Motor or 0603 Motors 19000KV / 16000KV to experience the different flying of our Meteor65.
Video for Meteor65
Bullet Point
Meteor65 is the first generation whoop drone powered by a brand-new BT2.0 1S battery. The BT2.0 connector effectively decreases internal connector resistance for a much better discharge performance compared with the initial PH2.0 connector.
Flight controller pre-soldered the BT2.0 cable, which can provide a more stable and powerful 9A continuous current and 15A burst.
For minimizing weight and optimal performance, it applies the perfect lightest combo with F4 1S AIO FC and C01 camera.
By using the latest 0802SE 19500KV motors and 31mm 3-blade props, this kit provides you a completely different experience of a powerful indoor flight.
Meteor65 lower profile frame is reduced 0.75g to 3.08g only. The battery slot is closer to the center of gravity for a smoother flying experience, and you will land on the motor screws instead of the battery.
The package comes with 2 lipo batteries, a BT2.0 charger & tester, an extra 1 set of props, 1 screwdriver, and a portable bag. Meanwhile, we have also released a BT2.0 Battery charger for your needs.
Flight time: 0802SE 19500KV motor version: 3:30min-4min / 0802 22000KV motor version: 1:30min-2min
BT2.0 Connector
BETAFPV exclusive designed BT2.0 connector has broken through the bottle-neck of PH2.0 connector. BT2.0 connector has decreased internal resistance of connector effectively allowing more current to be transferred, which means it supports 9A continuous current (15A burst). This means stronger power and longer flight time on 1S brushless drones while PH2.0 just supports 4.5A. You can enjoy more flight time without disturb of low voltage warning due to reducing voltage sag.
See the graph below of comparing the BT2.0 connector and PH2.0 connector (solid pin version) in BETAFPV 1S 300mAh battery. The discharge current is 9A in this test. The BT2.0 has double the time (about 2 minutes) and a 0.2v improvement in voltage sag.
Flight Controller
F4 1S AIO FC(SPI Rx) integrates 4 components as F411 FC, 5A ESC, 25mW VTX and SPI receiver. It is ultralight only 3.92g and still maintains an amazing performance capability, which makes it become your best choice to run with a 1S brushless quad!
F4 1S AIO FC(No Rx) integrates 3 components as F411 FC, 5A ESC and 25mW VTX. It supports external receivers like TBS Crossfire, Frsky XM+ and Spectrum DSMX etc.
In this quad, the Frsky & Futaba Version is equipped with F4 1S AIO FC(SPI Rx), and the TBS & PNP Version is equipped with F4 1S AIO FC(No Rx) with an external Receiver.
C01 Camera
C01 Camerais the lightweight camera customized for the weight-sensitive micro whoop drones, perfectly fits the Meteor65. Adapted a 1/4'' CMOS sensor, 2.1mm lens for 800TVL resolution and excellent latency while minimizing the weight to 1.4g. Packed with the micro canopy, protect your camera well in a hard crash.
Motors
0802SE 19500KV Motor is a lightweight 1S motor, compared with the 0802 series brushless motors, it is not only significantly reduced the weight which is only 1.83g/pc but also ensuring the awesome performance of power and thrust. Lead wire soldered to the PCB, which allows you to repair it easier once it disconnected.
And the Racing version of Meteor65 is using the 080222000KV motors, which uses a ball bearing instead of brass bushings, and PCB connector. More durable and easier to repair once disconnected.
Frame
The lightest lower profile 65mm frame- Meteor65 frame is reduced 0.75g to 3.14g only. The battery slot is closer to the center of gravity for a smoother flying experience, and you will land on the motor screws instead of the battery. There are more options for colorful frames such as Beta-blue, mint-green, sakura-pink, mango-orange, etc.
NewBeeDrone Max Comfort Goggle Foam for DJI Goggles 2
I have a slim face and slim nose. This foam is worse than the cheap aliexpress version. It tilts the goggles forward from the top and causes them to go out of focus and does not close in enough on the sides to block out the light. It is a fight to get them into a position where the screens are in focus and that they stay in place. DEFINITELY NOT WORTH THE MONEY!
I've now built three digiwhoops with Walksnail and I'm 100% a fan! Recently I was absolutely amazed when I was able to fly my 85mm into an elevator and keep signal riding up all three floors of the parking garage until the doors opened at the top. You can check it out here: https://youtu.be/4cbClBI6E78
Or watch my full review of the Walksnail system here: https://youtu.be/HACd0RQLykU
This is camera is Awesome! Can't wait to mount it in a wing. The formfactor puts in the mind of a HD camera. The lens is big for a camera of this size. It should fit any wing or 3"-5" build you mite be thinking about.