-Infinity305 Flight Controller Firmware on Official Betaflight Target name: NBD_INFINITYF4
Build Video:
We are offering a limited supply of the Infinity FC with a BlackBox pre-installed. The chip is a W25Q128JVSIM (128Mbit / 16MByte)
Flight Controller Spec:
MPU6000 Gyro
STM32F405 CPUE @ 168mhz, can be overclocked
3-6S direct battery input
5V 2A,
9V 2A 18W Design for DJI FPV Air Unit
5V Camera Power
betaflight OSD
Flat bottom PCB for SUPER CLEAN builds
36x39 CB with 30.5x30.5 mounting holes
6 UARTS. UART1 (INVERTER FOR SBUS)
UART2 (FREE)
UART3 (INVERTED TELEMETRY)
UART4 (Free)
UART5 (Smart Audio)
UART6(Free)
Built-in 4 IN 1 ESC socket(including ESC telemetry, External current sensor) JST1.0 8Pin
Plug and plug with NBD Infinity30 ESC. Also compatible with most of the ESC on the market.
Built-in solder pads for ESC signal output and power
Printed layout instructions ON the board - no need for instructions!
DJI FPV Air Unit socket (use UART1 and UART6)
Includes:
1x Infinity305 flight controller
4x Grommets short 4x Grommets Long
1x Infinity305 FC to DJI Air module cable 40mm
1x Infinity305 FC to DJI Air module cable 100mm
1x Infinity305 FC to DJI Air module cable 150mm
NOTE: We suggest running a cap on 4s builds. Even though we tested and designed it to not need one, all builds are different and there are always exceptions.
I love it ! Been flying it for years ! Why is this there no esc for it anymore ! I loved that too ! But I can’t fine one anywhere !ugh !
S
Steven
Awesome
I absolutely love this FC. It has performed very well so far and I have zero complaints. Easy to read and solder on. I personally love all Newbeedrone products and highly recommend this FC.
R
Ross peterson
Solid
Solid f4 fc ... Recommend
N
N.
Great flight controller.
This is my second FC and I love them. I ordered the black box chip for it as well.
These goggles are great, mainly due to the Steadyview VRX. Screen is bright and clearer than my EV800D, and looks better even though slightly smaller. These are much lighter weight and more comfortable.
Using in my goggles and in TX. In TX they work great as it uses a pair of them. Kind of short battery life on my goggles that only use one, but I charge both and just swap them out which works fine.
Compared to Matek M10Q-5883 on the same 7" quad and same location the Holybro M9N outperforms others in speed locking satellites, achieving DGPS. Also, due to the internal battery it retains previous GNSS location, satellites etc. for fast reboot in the same location.