This is our second generation motor design, we use unibell on this motor at the same time we switch to double step shaft. Without the C-Clips on top of the bell will make the motor balance to the next level. This motor is design to operate under 2S voltage ( 7.4V)
These motors come with JST-1.0 plugs installed but also come with a set of Micro JST-1.25's. The BeeBrain Brushless uses Flight controller uses JST-1.0 plugs.
Love these little motors in and they're great for 2s whoops
L
Lamont
Wobble = heat
Got these for a 75mm build on a mobula v3 frame replacing my happymodel motors for a new elrs build . All 4 of these are very loose on the shaft and have a lot of play at the bell causing excessive heat. These are unfortunately unusable . Only got about 8 flights out of these before they became completely unreliable.
C
Christopher H.
Running these 2s with bee brain v3
Great motors. Installed on a 75mm frame.
M
Michael
Espresso for 2s
This is my first experience with Newbeedrone on 2s. I used these because I snapped a shaft on my older set. These are holding up to the abuse.
I did use the suggested esc settings from the Hive group page and no problems from these. So far, awesome change.
I am using 40mm 3 blade pros at the moment and not planning on changing that for now.
These goggles are great, mainly due to the Steadyview VRX. Screen is bright and clearer than my EV800D, and looks better even though slightly smaller. These are much lighter weight and more comfortable.
Using in my goggles and in TX. In TX they work great as it uses a pair of them. Kind of short battery life on my goggles that only use one, but I charge both and just swap them out which works fine.
Compared to Matek M10Q-5883 on the same 7" quad and same location the Holybro M9N outperforms others in speed locking satellites, achieving DGPS. Also, due to the internal battery it retains previous GNSS location, satellites etc. for fast reboot in the same location.