iFlight ProTek35 CineWhoop w/ Caddx Polar Vista (Crossfire) 4S- BNF
After the very popular 3-inch Cinematic EVA bumper BumbleBee and Green Hornet CineWhoop series release, iFlight continue to strive to increase performance by coming up with their master Protek series. The Protek CineWhoop has a longer flight experience and weighs less than the previous cinewhoops!
iFlight was able to increase the speed and thrust by 50% compared to its 3-inch predecessor which gives a lot more room for a lot more fun; as a result, the ProTek35 is equipped with 2203.5 motors. It also features the Caddx Polar Vista, Beast F7 AIO Flight Controller, 45A 2-6S ESC, and the Nazgul 3535 propellers.
Note: Battery, GoPro, and GoPro mount NOT included
Features
No Props or frame in view!
High-performance True-AIO Board Beast Whoop F7 AIO 45A to save weight and space
T700 Quality Carbon (40% more tensile strength compared to common 3K carbon)
Lightweight one-piece frame design (Less flexibility, more Rigid, more Durable)
Low Resonance frame construction (Less Jello, more Cinematic footage)
Caddx Polar Vista compatible with DJI Digital FPV
Butter smooth 2203.5 3600KV (4S)
Pre-tuned with smooth freestyle settings
Pre-Tuned & Pre- Setup
Don't worry about tuning, iFlight did that for you already! A basic PID- and Filter tuning was applied for a great flight experience!
To restore lost tunes or updates, please check out this linked article: "Firmware/Factory Dumps"
Angle-Mode (self-balancing level mode) is enabled by default to make sure your first flight doesn't end in a mess!
I am kinda new to fpv drone flying but not new to RC and this radio is by far the best I’ve used. Definitely complicated and has a lot to lean but its loaded with features and is fully customizable and way more advanced then anything Ive used before. Coming from the Spektrum platform YouTube is your friend as there is a lot to learn.
had a few issues i used they ROBO 1002 and it fit fine without they carbon. but needs they carbon to hold battery had to use a mix of screws, had issues with props rubbing they frame with carbon using AZI props solved by not pressing props all the way down. I ordered they black and yellow, Black has a better mount for they antenna to keep in place !! yellow needs something to tie down
this gift would be nicer with a genuine properly welded whoop
Hello Franz,Thank you for the information provided. Do you have a hot air soldering station? You can use it to heat the capacitor, which should allow you to reseat it into position. After that, test to see if it's functioning properly within Betaflight. If everything is working correctly, you can further secure the capacitor with non-conductive adhesive.We sincerely apologize for the inconvenience caused. We have also credited your account with $10, which you can use to purchase any products from our store. If you have any questions or need further assistance, please feel free to reach out to us. We are always here to help. Thank you, NewBeeDrone Support
forgive waranty, buy an hot air soldering unit before !!!
Hello Franz,
Thank you for the information provided. Do you have a hot air soldering station? You can use it to heat the capacitor, which should allow you to reseat it into position. After that, test to see if it's functioning properly within Betaflight. If everything is working correctly, you can further secure the capacitor with non-conductive adhesive.We sincerely apologize for the inconvenience caused. We have also credited your account with $10, which you can use to purchase any products from our store. If you have any questions or need further assistance, please feel free to reach out to us. We are always here to help.