My new favorite FC. You have the pinout in the box and I haven't had any issues with it so far. I am currently using 4 of them.
D
Duncan Stewart
Good AIO, I made a mistake and burned out another one i guess?
I purchased two, put Conformal Coating onto these board before soldering the pads, mind you I put one small layer near the pads then proceeded to put two more layers on the rest of the boards knowing I will be back to put more on.
I got a Cold Solder Joint on the Negative Terminal, I tried to solder it back on, kept on popping off, I proceeded to put more solder on and it seemed to be stuck, then I tested the FC and it wasn’t working.
So it’s Toast, I tested the USB, toast. So I was able to get my second one to solder “welded” I’ve been flying that for a week, did the same process, but went back and tried to clean more of the Conformal Coating off with IsoPropyl.
I damaged it within a week of owning it, contacted NewbeeDrone and they push it along to HAKRC. I’ve been talking to them for a week, they asked the same questions over and over, I had to repeat myself to them, send tons of photos, while they lectured me on the “three defense” sequence of conformal coating.
Yeah I didn’t tin up the pads first, but the amount of Conformal Coating I put on shouldn’t have caused it not to make a good enough contact?
So I was talking to their “support” email and I just realized it’s not worth it to RMS the board especially since they kept on being vague with their answers.
I got a bunch of their boards, but I do have the most problem with Conformal Coating and their boards and me burning them out when I build or transfer.
Bought these to build a 7in 8S quad. The low kv is perfect for keeping the tip speed under Mach. These appear to be rebranded Emax EcoII, so decent quality. This quad is so powerful on 8S it's just silly. Happy Camper!
Good flier, handles the abuse a new flier like me has put it through
First prebuild from NBD. I swapped out the tracer RX for crossfire, initially had a no gyro flag on the AIO but was able to get it sorted with NBD support. Flying it is a good time and it’s held up well to some decent crashes. So far only thing(s) I’ve needed to replace has been a propeller and a M3x20 standoff. Took me too long to notice but the 2 aluminum pieces are for taking the O3 air unit from 25x25 mounting and making it 20x20.