NeutronRC AT32F435 mini AIO, 32 Bit AM32 ESC,Board Flight Controller with 25.5*25.5mm Mounting pattern for FPV drone
AboutATBETAFLIGHT, it is a special branch of BETAFLIGHT, which is different from the MCU master control using non-ST chips, has a lower price, and a complete BMI270 driver, allowing it to calibrate the gyroscope at startup and have better flight stability .
Currently, the QUICKSILVERfirmware has been perfectly supported, and it performs perfectly on a small frame with a protective frame
1. How to connect BETAFLIGHT CONFIG software and the difference with BF;
1.2, betaflight 10.9 Configurator Opens the following setting options
2. About the AM32 ESC, there is a known bug in the AM32 version of the website, which causes malfunctions after writing or modifying the ESC. We have submitted a PR to fix this issue. Currently, you can use the development version web configurator to modify the AM32 ESC configuration
About Betaflight's support for artery MCU:
The current BF 4.4.X version does not support the AT32F435 chip. Our default firmware is based on the 4.3.2 branch. At present, it is seen in the BETAFLIGHT code base that BF4.5 will soon support the AT32F435 chip, and the specific progress is uncertain.
How to update FC and ESC firmware, please refer to the download document
The default FC Flash ATbetaflight 4.3.2-RC4 firmware, ESC flash HF32 firmware, usually, you do not need flash FC and ESC firmware, just install and set related options according to your settings. HF32 ESC Configurator
Right away, this is the best 65mm Whoop I know. Not even close.
I ordered two, one is more or less stock, just the PEEK motor screws and V3 cockroach. The second is upgraded to 0702 27000kV but will go back because I like the 25000kV more because of smoother throttle response and perfect betaflight tune.
Now the but:
1. On both quads I had to replace the BeeEye for a spare one because both are out of focus.
2. the yellow props were way too loose and very brittle. I lost two on my maiden. Black, blue and red are very tight (too tight for such a fragile prop) but if you get them on without bending them, they will last.
3. why does the quad not come with the lighter frame right away?
4. PH2.0…. You know the drill.
On that price point, even after the frame and PEEK upgrade I can forgive these quality issues. Especially considering the great tune and quality FC and motors. But be sure to order a replacement cam and props right away.
This was kind of a late night lark. I'd seen this upgrade for the Mk3 for a while and pondered whether it was a gimmick or not, and I'm pleased to say it's a genuinely good upgrade. It has reduced the noise of my Mk3 considerably. I haven't noted any significant increase in print quality, but the old drone of the bed is gone and that's completely worth it.
Differences between V1.0 and V1.2
V1.2 Connect with DJI O3/VISTA
V1.2 packing list:
