NewBeeDrone 0802 14000KV Brushless Motors - Unibell Espresso Edition (Set of 4)

This is our second generation motor design, we use unibell on this motor at the same time we switch to double step shaft. Without the C-Clips on top of the bell will make the motor balance to the next level.  This motor is design to operate under 2S voltage ( 7.4V) 

These motors come with JST-1.0 plugs installed but also come with a set of Micro JST-1.25's. The BeeBrain Brushless uses Flight controller uses JST-1.0 plugs.

Note: These motors require a high performance battery such as the Nitro Nectar Gold 300mah HV 1s packs!

- 0802 Motor Size
- 14,000KV (Designed for 2s)
- 1mm double step Shaft
- Lead wire solder pads
- JST-1.0 Plugs installed
- 50mm cable length
- 2.08 grams each with wire and plug

Customer Reviews

Based on 10 reviews
Dan Sullinger
great motor

good for your build

Roberto Camacho
Love' em

Love these little motors in and they're great for 2s whoops

Wobble = heat

Got these for a 75mm build on a mobula v3 frame replacing my happymodel motors for a new elrs build . All 4 of these are very loose on the shaft and have a lot of play at the bell causing excessive heat. These are unfortunately unusable . Only got about 8 flights out of these before they became completely unreliable.

Christopher H.
Running these 2s with bee brain v3

Great motors. Installed on a 75mm frame.

Espresso for 2s

This is my first experience with Newbeedrone on 2s. I used these because I snapped a shaft on my older set. These are holding up to the abuse.
I did use the suggested esc settings from the Hive group page and no problems from these. So far, awesome change.
I am using 40mm 3 blade pros at the moment and not planning on changing that for now.