-Infinity305 Flight Controller Firmware on Official Betaflight Target name: NBD_INFINITYF4
Build Video:
We are offering a limited supply of the Infinity FC with a BlackBox pre-installed. The chip is a W25Q128JVSIM (128Mbit / 16MByte)
Flight Controller Spec:
MPU6000 Gyro
STM32F405 CPUE @ 168mhz, can be overclocked
3-6S direct battery input
5V 2A,
9V 2A 18W Design for DJI FPV Air Unit
5V Camera Power
betaflight OSD
Flat bottom PCB for SUPER CLEAN builds
36x39 CB with 30.5x30.5 mounting holes
6 UARTS. UART1 (INVERTER FOR SBUS)
UART2 (FREE)
UART3 (INVERTED TELEMETRY)
UART4 (Free)
UART5 (Smart Audio)
UART6(Free)
Built-in 4 IN 1 ESC socket(including ESC telemetry, External current sensor) JST1.0 8Pin
Plug and plug with NBD Infinity30 ESC. Also compatible with most of the ESC on the market.
Built-in solder pads for ESC signal output and power
Printed layout instructions ON the board - no need for instructions!
DJI FPV Air Unit socket (use UART1 and UART6)
Includes:
1x Infinity305 flight controller
4x Grommets short 4x Grommets Long
1x Infinity305 FC to DJI Air module cable 40mm
1x Infinity305 FC to DJI Air module cable 100mm
1x Infinity305 FC to DJI Air module cable 150mm
NOTE: We suggest running a cap on 4s builds. Even though we tested and designed it to not need one, all builds are different and there are always exceptions.
I love it ! Been flying it for years ! Why is this there no esc for it anymore ! I loved that too ! But I can’t fine one anywhere !ugh !
S
Steven
Awesome
I absolutely love this FC. It has performed very well so far and I have zero complaints. Easy to read and solder on. I personally love all Newbeedrone products and highly recommend this FC.
R
Ross peterson
Solid
Solid f4 fc ... Recommend
N
N.
Great flight controller.
This is my second FC and I love them. I ordered the black box chip for it as well.
Right away, this is the best 65mm Whoop I know. Not even close.
I ordered two, one is more or less stock, just the PEEK motor screws and V3 cockroach. The second is upgraded to 0702 27000kV but will go back because I like the 25000kV more because of smoother throttle response and perfect betaflight tune.
Now the but:
1. On both quads I had to replace the BeeEye for a spare one because both are out of focus.
2. the yellow props were way too loose and very brittle. I lost two on my maiden. Black, blue and red are very tight (too tight for such a fragile prop) but if you get them on without bending them, they will last.
3. why does the quad not come with the lighter frame right away?
4. PH2.0…. You know the drill.
On that price point, even after the frame and PEEK upgrade I can forgive these quality issues. Especially considering the great tune and quality FC and motors. But be sure to order a replacement cam and props right away.
This was kind of a late night lark. I'd seen this upgrade for the Mk3 for a while and pondered whether it was a gimmick or not, and I'm pleased to say it's a genuinely good upgrade. It has reduced the noise of my Mk3 considerably. I haven't noted any significant increase in print quality, but the old drone of the bed is gone and that's completely worth it.
