Atomrc Swordfish Build for FPV, Intelligence flight. -Flight controller have two firmware INAV or Arduplane, both firmware already pre-turned for the plane. RTH and RTH FPV version are plug and play, use just plug theire receiver and battery, plane is ready to go just like racing drones, no need glue or installed the electronics.
Arduplaneversion is also available, we can upload arduplane parameter setting on our web, you just need flash the arduplane firmware, load the settings.
Easy for beginners, pre turned and pre-installed electronics.
Auto launch mode, return to home, circle mode Need install the ATOMRC F405 NAVI flight controller, the RTH and RTH+FPV have intelligence flight mode.
Quick Release connector The quick release connector using soft connection, solved the disconnection from vibration or crash. Easy to install the wing and detach the wing.
Hatch Lock, The screw and nuts are more durable and reliable than magnet, the hatch will never fall off in the air.
Carbon fiber reinforcement and plastic injection mount for tail, more rigid for high speed and landing
Precise Plastic injection parts The wing connector, motor mount, VTX mount, V tail base and flight light cover are using precise Plastic injection parts, more durable and light weight.
Atomrc Swordfish versions: KIT Version: pre-glued fixed wing PNP Version: KIT+Motor+ESC+Servo FPV Version: PNP+VTX+Camera RTH Version: PNP+Pre-turned FC+GPS, all electronics are installed RTH+FPV Version: RTH+VTX+Camera, all electronics are installed
Good flier, handles the abuse a new flier like me has put it through
First prebuild from NBD. I swapped out the tracer RX for crossfire, initially had a no gyro flag on the AIO but was able to get it sorted with NBD support. Flying it is a good time and it’s held up well to some decent crashes. So far only thing(s) I’ve needed to replace has been a propeller and a M3x20 standoff. Took me too long to notice but the 2 aluminum pieces are for taking the O3 air unit from 25x25 mounting and making it 20x20.