VIFLY 1S Series Charging Board, Storage Charge and Discharge 1S LiPo Batteries with Standard Charger
Features:
- Storage charge 1S LiPo batteries with standard charger.
- Charge 1-6 batteries at the same time.
- Turn the knob for the number of batteries you are charging.
- The added fuse makes the board even safer.
- Pre-soldered PH2.0 and BT2.0 connectors /GNB27 connectors.
Warning:
- It is series board not parallel board. For example, when you are charging 4pcs 300mAh lipos, set your charger to 0.3A for 1C or 0.6A for 2C. NOT 1.2A or 2.4A.
- The specs of all batteries should be the same, ie, battery capacity, battery type, brand, etc.
- Never leave the board unattended while charging or discharging.
- Do not charge over 1.5amps. The fuse is 5A that not means you can charge it in 5A, the knob is rated for 1.5A so don't charge it over 1.5A.
- Don't plug in both PH2.0 and BT2.0 /GNB27 connectors battery in the same port.
Right away, this is the best 65mm Whoop I know. Not even close.
I ordered two, one is more or less stock, just the PEEK motor screws and V3 cockroach. The second is upgraded to 0702 27000kV but will go back because I like the 25000kV more because of smoother throttle response and perfect betaflight tune.
Now the but:
1. On both quads I had to replace the BeeEye for a spare one because both are out of focus.
2. the yellow props were way too loose and very brittle. I lost two on my maiden. Black, blue and red are very tight (too tight for such a fragile prop) but if you get them on without bending them, they will last.
3. why does the quad not come with the lighter frame right away?
4. PH2.0…. You know the drill.
On that price point, even after the frame and PEEK upgrade I can forgive these quality issues. Especially considering the great tune and quality FC and motors. But be sure to order a replacement cam and props right away.
This was kind of a late night lark. I'd seen this upgrade for the Mk3 for a while and pondered whether it was a gimmick or not, and I'm pleased to say it's a genuinely good upgrade. It has reduced the noise of my Mk3 considerably. I haven't noted any significant increase in print quality, but the old drone of the bed is gone and that's completely worth it.
![[pre-order]BetaFPV A03 400mW 5.8G VTX](http://newbeedrone.com/cdn/shop/files/8c6db81bad1f7fab20f937b5a3deb50b_720x_2e752615-4a65-4c95-a2d8-df964bdc15b6_{width}x.webp?v=1700635982)
![[pre-order]BetaFPV Aquila16 FPV Kit](http://newbeedrone.com/cdn/shop/files/2_720x_f35023be-a70b-48e4-97c5-277987d855e7_{width}x.webp?v=1700619059)
![[pre-order]BetaFPV Moxon Radio Transmitter Antenna V2 (1pcs)](http://newbeedrone.com/cdn/shop/files/MOXON2.4_720x_aa23e915-1266-4875-bf6e-91bd353c6047_{width}x.webp?v=1700537807)
