Small and sturdy. Optimized design obtained through massive impact tests. Flexible tube can withstand angle bends and crash impacts to avoid cable damage.
Thin cable. Teflon skin, double shielded RG-137 coaxial cable with silver plated core. This wire is soft flexible and low signal loss.
Between 5650 and 5950MHz, VSWR is below 1.2 meaning trasmission efficiency is up to 98% This can also help reduce VTX heat.
Quick installation. Antenna clips are designed to the same size as standard flange SMA sockets. The length of the antenna tube can be cut to meet your needs.
Quality Assurance. Cherry antennas are tuned for performance by the Rush FPV Professional Microwave Laboratory, and each antenna is qualified by a network analyzer before leaving the factory.
SPECIFICATIONS
Gain: 1.2dBi
S11 SWR: 1.4 max - 1.1 min
Band Width: 5600-6000-MHz
Axial Ratio: Around 1.0
Polarization: LHCP or RHCP
Connector: New designed UFL lock - pull the metal slot out so it releases and put antenna, slot it back for lock
Works good but the ufl lock is the best part.
The lock works great just don’t expect to get it unlocked…I tested the lock before install and ripped the ufl off one antenna.
J
Josef Dahari
Def a perfect replacement for vista
Perfect replacement for vista antenna that's for sure
R
Rob
Nice
Nice 2 antenna combo, worked well for my HDzero build
V
Vincent Bonadio
Antenna review
Is a great replacement antenna for my TBS unify nano pro32!
I
Impulsefpv
Simple, cheap, effective
When thrashing your quads ends up with broken vista antennas, cherries will get you back in the air. With the benefit of a locking ufl clip!
Right away, this is the best 65mm Whoop I know. Not even close.
I ordered two, one is more or less stock, just the PEEK motor screws and V3 cockroach. The second is upgraded to 0702 27000kV but will go back because I like the 25000kV more because of smoother throttle response and perfect betaflight tune.
Now the but:
1. On both quads I had to replace the BeeEye for a spare one because both are out of focus.
2. the yellow props were way too loose and very brittle. I lost two on my maiden. Black, blue and red are very tight (too tight for such a fragile prop) but if you get them on without bending them, they will last.
3. why does the quad not come with the lighter frame right away?
4. PH2.0…. You know the drill.
On that price point, even after the frame and PEEK upgrade I can forgive these quality issues. Especially considering the great tune and quality FC and motors. But be sure to order a replacement cam and props right away.
This was kind of a late night lark. I'd seen this upgrade for the Mk3 for a while and pondered whether it was a gimmick or not, and I'm pleased to say it's a genuinely good upgrade. It has reduced the noise of my Mk3 considerably. I haven't noted any significant increase in print quality, but the old drone of the bed is gone and that's completely worth it.
