SpeedyBee F745 35A BLS 25.5x25.5 AIO Flight Controller

    Important Note:
    Make sure the AIO's slightly bigger size can fit your own quad! The size of this AIO is 36.5(L)*36.5(W)*7.0(H)mm.
    We suggest you use this AIO on your 3.5" to 5" cinewhoops/long-range or lightweight quads.For quads below 3.5",
    you should carefully check if your quad has enough room for this AIO.
     
     
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    SpeedyBee F745 35A AIO
    Specifications
    Overview
    Product Name SpeedyBee F745 35A BLS AIO
    Power Input 3S - 6S Lipo
    Mounting 25.5 x 25.5mm, 3mm hole diameter
    Dimension 36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5" or above
    Weight 10.1g
    FC
    MCU STM32F745
    IMU(Gyro) MPU6000
    USB Connection Need to solder a USB TYPE-C module to D+,D-,GND pads.
    Barometer BMP280
    OSD Supported
    BLE Bluetooth Supported. Used for parameter configuration,built-in a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip
    Flash FC Firmware Wirelessly Supported
    Download/Analyze Blackbox Supported
    DJI Air Unit 6-pin Connector Built-in.
    Flash(for BlackBox) 8MB
    Current Sensor Supported. Scale=256
    BetaFlight Camera Control Pad Yes(CC pad)
    5V Output 4 groups of 5V output. The total current load is 2.5A.
    9V Output None
    ESC Signal Pads M1 - M4
    UART Full UART * 4(UART1, UART2, UART3,UART4)
    ESC Telemetry UART None
    I2C Supported.
    LED Pad Used for WS2812 LED
    Buzzer BZ+ and BZ- pad used for 5V Buzzer
    BOOT Button Used to enter DFU mode
    RSSI Input Not supported
    SmartPort Not Supported
    Supported Flight Controller BetaFlight(Default)
    Firmware Target Name SPEEDYBEE F745AIO
    ESC
    Power Input 3-6S LiPo
    Continuous Current 35A * 4
    Burst Current 45A(5seconds)
    ESC Protocol DSHOT300/600
    Power Output VBAT
    Current Sensor Supported(Sacle=256)
    Firmware BLHeli_S JH40

    Customer Reviews

    Be the first to write a review
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)