This is our second generation motor design, we use unibell on this motor at the same time we switch to double step shaft. Without the C-Clips on top of the bell will make the motor balance to the next level. This motor is design to operate under 2S voltage ( 7.4V)
These motors come with JST-1.0 plugs installed but also come with a set of Micro JST-1.25's. The BeeBrain Brushless uses Flight controller uses JST-1.0 plugs.
Love these little motors in and they're great for 2s whoops
L
Lamont
Wobble = heat
Got these for a 75mm build on a mobula v3 frame replacing my happymodel motors for a new elrs build . All 4 of these are very loose on the shaft and have a lot of play at the bell causing excessive heat. These are unfortunately unusable . Only got about 8 flights out of these before they became completely unreliable.
C
Christopher H.
Running these 2s with bee brain v3
Great motors. Installed on a 75mm frame.
M
Michael
Espresso for 2s
This is my first experience with Newbeedrone on 2s. I used these because I snapped a shaft on my older set. These are holding up to the abuse.
I did use the suggested esc settings from the Hive group page and no problems from these. So far, awesome change.
I am using 40mm 3 blade pros at the moment and not planning on changing that for now.
Great pouch! Goggles 2 fit perfectly. Outside pocket holds one battery and cable. I feel comfortable leaving the eye lens cover off and just putting goggles in bag when not in use.
It is unfortunate that this is basically the only super lightweight RID module, because I have heard a lot of issues with them just straight up not working. Essentially a worthless product. Does not obtain any satellites. I have contacted DroneTag support and they tried troubleshooting a little and then recommended I pay to ship the product all the way back to the Czech Republic… I contacted NewBeeDrone support for a return and they have not responded in 2 business days. I am hoping I will be able to return this or swap it for another unit (if its just a faulty one).