• 
• 
• 
• 
• 

Holybro PM02 V3 Power Module (12S)

The Holybro PM02 V3 Power Module (12S) is a reliable and efficient power solution designed for your drone setup. This power module provides a robust 12S voltage input, making it suitable for a wide range of high-performance applications. With built-in current and voltage sensing capabilities, the PM02 V3 ensures that you can monitor your system’s power consumption accurately.

Key Features:

• 12S Voltage Input: Supports up to 12S LiPo batteries, making it perfect for high-voltage applications.
• Current and Voltage Sensing: Integrated sensors provide real-time data for enhanced performance monitoring.
• Compact and Lightweight: The lightweight design ensures minimal impact on your drone's overall weight, allowing for better flight dynamics.
• Easy Integration: Designed to seamlessly connect with various flight controllers, simplifying installation and setup.

Upgrade your drone’s power management with the Holybro PM02 V3 Power Module, ensuring optimal performance and reliability during your flights.

Description:

This PM02 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.
 
Specification:

• Input Voltage: 2S-12S
• PCB Cont. Current Rating: 60A
• PCB Burst Current Rating: 100A (<60 Sec)
• Max Current Sensing: 120A
• Output: DC 5.2V & 3A Max
• Voltage Divider: 18.182
• Amperes per Volt: 36.364 
• Weight: 20g

Please Note: 

- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 
- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). 

Package Includes：

- 1x Power Module with XT60 Connectors Board (pre-soldered)
- 1x Electrolytic capacito: 220uF 63V (pre-soldered)
- 1x Molex 6 Position Connector 15 cm
- 1x JST GH 6 Position Connector 15 cm 

Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.