There is nothing like the experience of flying an FPV drone, but building these marvelous machines is more complex than it needs to be. With Tramp, we set out to raise the bar on video transmitter technology. With Ghost, we set out to redefine the norms in receivers for R/C control. And now we have fused these two together, in the groundbreaking Ghost Hybrid. Designed by pilots, built by pilots, supported by pilots.
FEATURES
- 20x20, 25.5x25.5 mounting - single sided, with included gummies, for extremely low profile mounting - Two full receiver channels (not just dual antenna) - Only 2.2g, perfect for the popular sub-250g class - Extreme Range AND Low Latency - 500Hz R/C Link Updates (HW is 1kHz ready) - 2.4GHz Lora OR FLRC control modes, for the best performance in any environment - Integrated 5.8GHz 25mW - 600mW Video Transmitter - All 48 standard channels - Thermally Regulated, Factory Calibrated
INTELLIGENT VTX CONTROL
Intelligent, and direct control of the video transmitter from the Ghost ecosystem. Use either the OLED menus on the Ghost Transmitter module or the responsive OpenTx tools menu. Tx remains silent on power-up, shuts down immediately in an (unlikely) failsafe.
LOCKING CONNECTORS
Innovative locking connectors deliver the advantages of the light-weight u.FL/MHF standard, with the security required for world-class racing, or long-range flying. Simply plug the connector onto the board, and slide the locking cap to secure.
THERMAL REGULATION + CALIBRATION
As with all tramp products, the Hybrid includes automatic thermal regulations, protecting the video transmitter against potentially damaging overheating while sitting on the starting pad. The on-board Tramp is factory calibrated, for precise power delivery during critical race events.
qTee ANTENNAS
qTee, a.k.a ‘Cutie’ antennas are center-fed dipoles, with integral balun to ensure no cable radiation, and without unexpected nulls in the radiation pattern. Tip to Tip length of just 60mm, easy to install in anything from a Whoop™ to an X-Class quad
SPECIFICATIONS
Downlink RF Power: +13dBm
Sensitivity: -117dBm in Long Range mode
Serial Formats: GHST, SBus, SBus-Fast (200k), SRXL-2 (400k), SBus Inverted
Firmware: Over-the-air (OTA) upgradeable (Rx and VTx)
Power Supply: 5V, with Over Voltage Protection
VTX Control: Automatic, via Ghost
Antenna Connectors: Standard U.FL with Locking Connectors
Update process is cumbersome, better if done with the VTX out of the quad. Also the update port is much flimsier than the earlier 2 antenna versions, IMO.
I use this mont for all my builds with a DJI O3 system. It comes with all the hardware nessassery and I like how is provides a small gap between the frame and the air unit so you can run wires under it. With all that said, it is still very low profile to fit on builds that use short 20mm standoffs too.
This thing is really fun and I haven't had to touch the PIDs at all. Super maneuverable on high rates and really mellow on low rates. I'm teaching my six year old grandson how to fly and he's doing great with it then raise the rates and I doing freestyle in my livingroom. Top off the performance with Newbeedrones awesome customer service and you can't lose. Newbeedrone is now my go to site for whoop stuff.
