Each order comes with 3 sets of props a total of 12.
Geometry:
3 inch diameter
2.4 inch pitch
3 blades
Inertial Properties:
weight: 1.25 grams
Moment of Inertia: 3.05 g/cm^2
The Emax Avan Mini propeller 3x2.4x3 was designed for Babyhawk Race 3 inch to maximize flight time and performance. This propeller is matched to Emax 1106 4500kv for 3s and 4s flight. A true 2.4" pitch throughout the blade gives a linear control feeling across the throttle band while still achieving high speeds. This allows for ease of flight and more precision. With a special PC blend the Avan Mini weighs 1.25 grams. Most of the weight is centralized near the hub creating a low moment of inertia of 3.05 grams*square centimeter which in turn makes a very responsive prop. The large blade chord makes the propeller very durable.
The Avan Mini was designed from the ground up starting from design constraints such as RPM, air speed, and required thrust. From these constraints aerodynamic models were built to predict performance and to design the blade shape. Highly cambered airfoils were used to achieve high lift coefficients at high angles of attack prolonging stall. This allows for a higher blade angle while still remaining efficient. The cambered airfoils also allow a greater flight envelope making for great low end responsiveness while still being able to achieve high speeds.
A special Polycarbonate blend is used to achieve high durability. This material is incredibly tough and ductile to resist fracture in high impact crashes. A thick blade root was designed to further increase this durability. Our injection mold process is optimized to reduce bubbles in the plastic to increase the strength of the propeller and to maintain superb balance.
It has a rather bad tune and no ability to tune it but it is flyable so I guess it does its job. Good luck growing with it though. I would recommend a nicer micro than this one.
Although this frame has a slight “slammed” profile, it still fits a full size f7 stack. My new favorite frame tbh! Black box shows very little motor noise or frame resonance. It’s GOOD!
UserGot the Axisflying Z20 and one Motor burned out on the first day. They seem to be quite fragile.
For the Frame itself it is quite hard to work on. As of now I remove two of the motors to be able to access the flight controller, air unit etc.. There are more robust and better built 2'' drones available