NewBeeDrone SavageBee 3 吋牙籤架

SavageBee 框架經過專門設計,適合任何無刷 NewBeeDrone 百日咳飛行控制器,以建造輕型 1 秒或 2 秒牙籤微型無人機。

底板厚度為 2.5 毫米,非常耐用,而且由於精確的切口而沒有不必要的結構重量。

易於建構

其他3吋牙籤架需要細緻、困難且微小的焊接。透過 NewBeeDrone Hummingbird Pro 和 BeeBrain BLV3 飛行控制器,製作這款牙籤非常簡單!唯一需要的焊接是將馬達連接到 ESC。 BeeBrain BLV3 具有大型焊盤,可適應客製化建造。

規格

  • 碳纖維:2.5mm厚度
  • 幾何形狀: X 框架
  • 馬達對角距離:115mm
  • 馬達安裝圖案:9x9 毫米方形

建構建議

推薦 1 顆電池:

推薦 2 顆電池:

注意:隨附的電池支架僅適用於 1x 250 mAh 或 300 mAh 1s 電池。要安裝 2 顆電池,建議使用橡皮筋。


    Customer Reviews

    Based on 16 reviews
    94%
    (15)
    6%
    (1)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    D
    Dexter Domingo

    NewBeeDrone SavageBee V1.8 Frame 65mm/3inch

    J
    Jon
    Lots of mounting hardware

    This is an awesome replacement frame for a toothpick I build a couple years ago. More than enough spare screws to take care of the build. Very clean with a podracer aio.

    A
    Aadric Allan
    long lasting

    had some very fast crashes today and its still ok

    S
    SittingDuck
    Very tight squeeze for Happy Model X12 ELRS AIO FC

    Nice durable looking frame, I've had several light crashes into rubble and it still looks new.

    I've built mine with the Happy Model X12 ELRS AIO FC, 1202 NewBeeDrone Flow motors, and Goober canopy. The frame doesn't allow enough clearance for the motor connectors on the FC. I had to cut off all the plastic around motor connector pins and solder the motor wires to the pins. The Goober canopy fits the FC nicely but the ceramic SMT ELRS antenna just touches the canopy. I'm considering using a Dremel tool carefully cut out part of the canopy to leave more clearance for the antenna. This will prevent the canopy from damaging the antenna during a crash but will also leave the antenna a little bit more exposed.

    But overall, very happy with the frame

    D
    Dan Stocker
    Brilliant, quiet frame

    You can get away with very little filtering using this frame in a 2S build. It's also quite versatile re. accommodating AIO boards of different kinds. And it looks nice, too!

    I only wish there was a DXF or STEP file available for it to make designing TPU parts less of a hassle.