The V5 nano® is an autopilot designed by the CUAV® and PX4 teams for businesses or enthusiasts who are extremely sensitive to space but want to get the power of V5. Its design is based on the Pixhawk FMUv5 standard and is perfectly compatible with PX4 and ArduPilot firmware.
Previous
Next
Tiny & Powerful
The V5 nano is smaller in design than the V5, but its performance is not compromised. It is equipped with a high-performance STM32F765 processing chip and four sets of full-interface isolation protection chips to avoid electrostatic breakdown. The IO level is not compatible with the problem of breakdown master.
Dual platform compatible
Support the current mainstream PX4 and Ardupilot two open source platform firmware to meet the needs of different users.
Multi-sensor redundancy combination
Built-in five sets of sensors, the flight controller monitors the multi-channel sensor data in real time, and performs redundant switching immediately after a fault, improving flight safety and stability.
Custom 2.6mm pitch IO
Customizing 2.6mm pitch IO for V5 nano, solving the problem of multiple interfaces being crowded and difficult to disassemble.
Specification /V5 nano flight controller
Hardware parameter
Processor
STM32F427
sensor
Accelerometer
ICM-20608
Gyro
ICM-20608
Compass
HMC5983
Barometer
MS5611
Interface
Mavlink UART
2
GPS UART
2
DEBUG UART
1
Remote control signal input protocol
PPM/SBUS/DSM/DSM2
RSSI input
PWM or 3.3 analog voltage
I2C
1
CAN
1
ADC input
6.6V X1
PWM output
6 PWM IO
Support model
Copter/Plane/Helicopter/VTOL/unmanned vehicle/Rover, etc.
Bought these to build a 7in 8S quad. The low kv is perfect for keeping the tip speed under Mach. These appear to be rebranded Emax EcoII, so decent quality. This quad is so powerful on 8S it's just silly. Happy Camper!
Good flier, handles the abuse a new flier like me has put it through
First prebuild from NBD. I swapped out the tracer RX for crossfire, initially had a no gyro flag on the AIO but was able to get it sorted with NBD support. Flying it is a good time and it’s held up well to some decent crashes. So far only thing(s) I’ve needed to replace has been a propeller and a M3x20 standoff. Took me too long to notice but the 2 aluminum pieces are for taking the O3 air unit from 25x25 mounting and making it 20x20.