Super hardware and running speed Equipped withSTM32F722 MCUwhich has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor. It can perfectly support bidirectional DShot digital throttle communication. The integrated OSD chip can adjust and set each OSD parameters in FC parameter adjustment software and radio, which is simple and convenient. On-board large capacity Flash memory chip can record and store more flight logs, which is convenient for users to debug aircraft based on flight data.
Special interface for DJI image transmission system With DJI image transmission system port, equipped with corresponding flat cable (FC has been equipped), can avoid welding, realize plug and play.
On-board 5V & 12V dual BEC circuit FMU integrates with 12V BEC circuit. It can supply super power output for image transmission and 12V LED devices.
On-board Pit Switch module FC integrated Pit Switch module can open or close VTX by radio after being adjusted on FC parameter software. Easy and convenient.
Perfectly support firmware of various FPV It support the firmware of BetaFlight , Cleanflight , Butterflight , inva and other mainstream FPV, and can use corresponding parameter adjustment software to adjust various parameters, making the FC more suitable for various FPV flight and race.
Unique installation design and shock absorption structure The double hole distance mounting hole design (30 * 30MM & 20 * 20MM) can adapt to different frames. The unique flexible flat cable connection mode (The effect is better with hobbywing tower 4in1 ESC ), and the shock absorption mechanism of installation hole, can effectively reduce the impact of external vibration on FC high-sensitivity components, and make the flight more stable and accurate.
Perfectly match with Hobbywing ESC Match with Hobbywing tower 4in1 ESC, easy to install and wire. The appearance is more beautiful.
Volt/Amp monitoring portallows users to check the battery voltage (BAT port) and current (CRT port , extra current meter is needed).
Buzzer outputport allows users to connect external buzzer(s) to the FC for warning or informing the flight status of the aircraft.
Micro USBport allows users to connect the FC to a PC to flash firmware and adjust parameters.
Switch module of board load graphic transmission(VTX)can use remote control to control switch of graphic transmission.
they have a nice grippy slightly rounded top for thumbers, which I have always been, but they are also scalloped with 2 different radius for hybrid pinchers which I have wanted to use but never felt comfortable with until now. I think I am switching thanks to these sticks. fits my AG01 perfectly.
I bought it for longer flights with 6s motors, so that I can have more control and smoothness for cinematic stuff. I haven’t tested it to it’s limits because I don’t have any 5” quads with motors over 1960kv so I can’t take advantage of the C-rating the way a 4S motor would, but it has held up for me.
Stout boy. Lots of room for electronics and room for the new elrs gemini chip. I look forward to building this out and sending her Loooooong Range on MountaineerFPV on Youtube
![[pre-order] SpeedyBee 5.8 GHz Antenna V2 SMA](http://newbeedrone.com/cdn/shop/files/1000-9__56467_{width}x.jpg?v=1695705569)
![[pre-order] HDZero Freestyle V2 Kit](http://newbeedrone.com/cdn/shop/files/all_{width}x.png?v=1694509846)
