Note: the Infinity200 FC now uses a USB-C connector.
-Infinity200 Flight Controller Firmware on Official Betaflight Target name: NBD_INFINITYF4
Flight Controller Spec:
MPU6000 Gyro
STM32F405 CPUE @ 168mhz, can be overclocked
3-6S direct battery input
5V 2A
9V 2A 18W Design for DJI FPV Air Unit
5V Camera Power
betaflight OSD
31.5x27 CB with 20x20 mounting holes, weight: 5.85g
6 UARTS. UART1 (INVERTER FOR SBUS)
UART2 (FREE)
UART3 (INVERTED TELEMETRY)
UART4 (Free)
UART5 (Smart Audio)
UART6(Free)
Built-in 4 IN 1 ESC socket(including ESC telemetry, External current sensor) JST1.0 8Pin
Plug and plug with NBD Infinity200 ESC. Also compatible with most of the ESC on the market.
Built-in solder pads for ESC signal output and power
Printed layout instructions ON the board - no need for instructions!
DJI FPV Air Unit socket (use UART1 and UART6)
Pinout for USB-C Version (Recent)
Pinout for Micro USB Version
Includes:
1x Infinity200 flight controller
4x Grommets short 4x Grommets Long
1x Infinity200 FC to DJI Air module cable 40mm
1x Infinity200 FC to DJI Air module cable 100mm
1x Infinity200 FC to DJI Air module cable 150mm
NOTE: We suggest running a Electrolytic capacitor on 4s builds. Even though we tested and designed it to not need one, all builds are different and there are always exceptions.
This flight controller has plenty of capacitance. You do not need to put a cap on this flight controller There will always be voltage spikes this flight controller seems to be handling all of them just fine The best part is no part I have never ran into a problem with this flight controller If you feel more comfortable putting a cap on this flight controller then put a cap on it In my opinion you do not need one from an engineering perspective you do not need 1
Good flier, handles the abuse a new flier like me has put it through
First prebuild from NBD. I swapped out the tracer RX for crossfire, initially had a no gyro flag on the AIO but was able to get it sorted with NBD support. Flying it is a good time and it’s held up well to some decent crashes. So far only thing(s) I’ve needed to replace has been a propeller and a M3x20 standoff. Took me too long to notice but the 2 aluminum pieces are for taking the O3 air unit from 25x25 mounting and making it 20x20.