NewBeeDrone SavageBee 3" Toothpick Frame

The SavageBee frame was specially designed to fit any brushless NewBeeDrone whoop flight controller to build a lightweight 1s or 2s toothpick micro drone.

At 2.5mm thick, the base plate is durable but also has no unnecessary structural weight from the precise cutouts.

Easy to Build

Other 3 inch toothpick frames require meticulous, difficult, and tiny soldering. With the NewBeeDrone Hummingbird Pro and BeeBrain BLV3 flight controllers, building this toothpick is easy! The only soldering necessary will be to connect the motors to the ESC. The BeeBrain BLV3 has large soldering pads to accommodate for custom builds. 

Specifications

  • Carbon Fiber: 2.5mm thickness
  • Geometry: X frame
  • Diagonal Motor Distance: 115mm
  • Motor Mounting Pattern: 9x9 mm square

Build Recommendations

Recommended 1s Batteries: 

Recommended 2s Batteries:

Note: the included battery mount only fits 1x 250 mAh or 300 mAh 1s battery. To mount a 2s battery, rubber bands are recommended.


    Customer Reviews

    Based on 16 reviews
    94%
    (15)
    6%
    (1)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    D
    Dexter Domingo

    NewBeeDrone SavageBee V1.8 Frame 65mm/3inch

    J
    Jon
    Lots of mounting hardware

    This is an awesome replacement frame for a toothpick I build a couple years ago. More than enough spare screws to take care of the build. Very clean with a podracer aio.

    A
    Aadric Allan
    long lasting

    had some very fast crashes today and its still ok

    S
    SittingDuck
    Very tight squeeze for Happy Model X12 ELRS AIO FC

    Nice durable looking frame, I've had several light crashes into rubble and it still looks new.

    I've built mine with the Happy Model X12 ELRS AIO FC, 1202 NewBeeDrone Flow motors, and Goober canopy. The frame doesn't allow enough clearance for the motor connectors on the FC. I had to cut off all the plastic around motor connector pins and solder the motor wires to the pins. The Goober canopy fits the FC nicely but the ceramic SMT ELRS antenna just touches the canopy. I'm considering using a Dremel tool carefully cut out part of the canopy to leave more clearance for the antenna. This will prevent the canopy from damaging the antenna during a crash but will also leave the antenna a little bit more exposed.

    But overall, very happy with the frame

    D
    Dan Stocker
    Brilliant, quiet frame

    You can get away with very little filtering using this frame in a 2S build. It's also quite versatile re. accommodating AIO boards of different kinds. And it looks nice, too!

    I only wish there was a DXF or STEP file available for it to make designing TPU parts less of a hassle.