In a race, microseconds count. Goggles down, thumbs up - are you ready for a true 250Hz radio link? End to end latency: barely noticeable. Nothing else comes close! Thanks to 2.4GHz technology, we took the best from Crossfire and shrunk it down to speed it up. The end result: Smaller antennas, more speed, range for days.
Brand new 2.4GHz technology not found in any other radio link
3ms end to end latency
Crossfire engine for ultimate compatibility and functionality
"JR" and "LITE" form factor transmitters
Nano-sized receiver with antenna diversity
15mi+/25km+ range
For drones, planes, helicopters, cars and boats
THE FASTEST RADIO LINK
In a race, microseconds count. Goggles down, thumbs up - are you ready for a two-way 250Hz radio link? End to end latency: basically zero (okay, 3ms!). Range: for days. Nothing comes close! We took the best from Crossfire and shrunk it down & sped it up.
NOT JUST FOR RACE AND "FREERANGE" PILOTS
A single operation mode satisfies all requirements. A spine-tingling 250Hz refresh rate. Plenty of penetration and range to outperform even the most serious video link. Full telemetry capability is standard, without any range degradation! Thanks to Crossfire pedigree, drone pilots, traditional R/C pilots and everyone in between can instantly tap into the familiar lineup of compatible software, devices, remotes and mounting boards.
EASE OF USE
OTA firmware updates, auto-bind, multi-bind, LUA device configuration such as flight controller PIDs, etc. and cloud connectivity: No problem! These are all features that TBS first brought into the R/C space with TBS Crossfire! All receivers arrive in binding mode and it remembers your bind across all of your radios, so the bind button is technically not needed ever.
UNDER THE HOOD
TBS Tracer runs on the Crossfire engine. Over 6 years of active development and by far the most popular R/C system for FPV enthusiasts! You instantly tap into the same reliability, features and compatibility that drone pilots see as synonymous to peace of mind. So what's the difference? Higher update rate, lower latency, smaller antennas due to higher frequency. Crossfire users will feel right at home!
THE TBS GUARANTEE
In our over 10 years of our existence, software updates have always been free, continuous and plenty. Hardware is built for longevity and comes packed with a great range of features that are yet to be unlocked. Support has always been laser-focused on customer satisfaction. For pilots, by pilots.
It is the reason why TBS products have the largest following, and why investment into TBS Tracer will continue to pay dividends in future - just like TBS Crossfire continues to do for all hobbyists. As a thank you from us for your support, visit our website and enter the serial number of your Crossfire as Coupon Code for 30% OFF on all TBS Tracer TX & RX products!
FEATURES:
Long range, adaptive and robust remote control system for your drone & aircraft
Low latency, 250Hz update rate (5x faster than typical - world's fastest) for mind-blowing accuracy
Two-way communication link with real-time link vitals and telemetry
OTA firwmare updates, auto-bind, multi-bind support
TBS Cloud connectivity with telemetry output for smartphone apps
Fully configurable by OpenTX and TBS TANGO remote using CRSF protocol
"Unlimited" amout of people can fly at the same time
Selectable RF power from 25mW to 1W (local restrictions apply)
8 or 12ch output via CRSF, SBUS, inverted SBUS or PPM
Serial Modem capable of transmitting MAVLink or other serial protocols (up & downlink)
Radio Compatibility: LITE module bay (e.g. TBS Tango 2, Taranis X-Lite, X9 Lite), OpenTX V2.1+. The TBS Tracer Nano TX is suggested for use in Futaba and Spektrum remotes that do not have a JR-module bay.
* output power modes may not be available due to local regulation limitations
Update process is cumbersome, better if done with the VTX out of the quad. Also the update port is much flimsier than the earlier 2 antenna versions, IMO.
I use this mont for all my builds with a DJI O3 system. It comes with all the hardware nessassery and I like how is provides a small gap between the frame and the air unit so you can run wires under it. With all that said, it is still very low profile to fit on builds that use short 20mm standoffs too.
This thing is really fun and I haven't had to touch the PIDs at all. Super maneuverable on high rates and really mellow on low rates. I'm teaching my six year old grandson how to fly and he's doing great with it then raise the rates and I doing freestyle in my livingroom. Top off the performance with Newbeedrones awesome customer service and you can't lose. Newbeedrone is now my go to site for whoop stuff.